What Causes Noise in Your Dryer?

If your dryer is noisy, then it only means that it’s not working as it should. You have to call in the experts in dryer repair Frederick to help you out. They know exactly what to do in this type of situations and they’ll make sure that your dryer is fixed in no time.

When your dryer is noisy, you have to know where the issue is coming from. Dryers have different components and each of them has to work properly in order to perform its task correctly. Here are the different dryer parts that you have to take into consideration if your dryer is noisy.

1. Slides or Glides

Electric and gas clothes dryers have drum slides and glides that support the front and sides of the drum. These glides are with Teflon, plastic, or nylon while the backing is usually made of felt, cork, and plastic. Glides are installed to provide the drum with a smoother surface to work with. The drum inside the dryer rotates all the time, which is why they tend to wear out with prolonged use. The noise in your dryer is usually caused when the cover makes a scraping sound on the sides of the drum.

2. Bearings

Some types of electric and gas dryers have drums supporting the rear with bearings. Such bearing may come in a ball and socket type and then connected to the dryer using sleeve bushings. If the bear is defective, then it a squeaking or squealing noise is heard.

3. Rollers and Shaft

Some types of electric and gas dryers use rollers to serve as drum support. Such rollers can be seen near the bulkhead, usually in front. The rollers may wear and cause the erratic drum rotation. That would create squealing and thumping noises. If that is the case, then the drum rollers must be replaced entirely. The shaft, on the other hand, has to be duly inspected and then replaced if needed. To access the drum rollers the front panel of the dryer and the drum will need to be removed.

4. Belt

The belt is needed to rotate the drum of both electric and gas dryers. If the belt is not working well, then a thumping noise is heard as it turns. Belts get brittle and hard after prolonged use. Belts have to be inspected regularly and it is done by visually taking off the front panels or on some models, lifting the top. Belts showing signs of fraying and cracking have to be replaced.

5. Pulley

Dryers are equipped with pulleys and their purpose is to provide tension to the drum. With the pulley installed, the belt won’t slip. However, these pullers rotate at very high speed and may fail over time. When that happens, a squealing or squeaking noise is heard. If it is not addressed immediately, the problem can advance into loud thumping or scraping noises.

6. Drum Seal

Drum seals prevent excess air from getting into the drum and acting as a cushion between the drums and bulkheads. If this seal is broken, then a thumping or scraping noise is produced.

Leave a Reply

Your email address will not be published. Required fields are marked *